STTY(1) STTY(1)
NAME
stty - set terminal options
SYNOPSIS
stty [ option ... ]
DESCRIPTION
Stty sets certain I/O options on the current output termi-
nal. With no argument, it reports the current settings of
the options. The option strings are selected from the fol-
lowing set:
even allow even parity
-even disallow even parity
odd allow odd parity
-odd disallow odd parity
raw raw mode input (no erase, kill, interrupt, quit,
EOT; parity bit passed back)
-raw negate raw mode
cooked same as `-raw'
cbreak make each character available to read(2) as
received; no erase and kill
-cbreak make characters available to read only when newline
is received
-nl allow carriage return for new-line, and output CR-LF
for carriage return or new-line
nl accept only new-line to end lines
echo echo back every character typed
-echo do not echo characters
lcase map upper case to lower case
-lcase do not map case
-tabs replace tabs by spaces when printing
tabs preserve tabs
ek reset erase and kill characters back to normal # and
@
erase c set erase character to c. C can be of the form `^X'
which is interpreted as a `control X'.
kill c set kill character to c. `^X' works here also.
cr0 cr1 cr2 cr3
select style of delay for carriage return (see
ioctl(2))
nl0 nl1 nl2 nl3
select style of delay for linefeed
tab0 tab1 tab2 tab3
select style of delay for tab
ff0 ff1 select style of delay for form feed
bs0 bs1 select style of delay for backspace
tty33 set all modes suitable for the Teletype Corporation
Model 33 terminal.
tty37 set all modes suitable for the Teletype Corporation
STTY(1) STTY(1)
Model 37 terminal.
vt05 set all modes suitable for Digital Equipment Corp.
VT05 terminal
tn300 set all modes suitable for a General Electric Ter-
miNet 300
ti700 set all modes suitable for Texas Instruments 700
series terminal
tek set all modes suitable for Tektronix 4014 terminal
hup hang up dataphone on last close.
-hup do not hang up dataphone on last close.
0 hang up phone line immediately
50 75 110 134 150 200 300 600 1200 1800 2400 4800 9600 exta extb
Set terminal baud rate to the number given, if pos-
sible. (These are the speeds supported by the DH-11
interface).
SEE ALSO
ioctl(2), tabs(1)